Davies Craig Universal Fan Mounting Kit 12V 1000
Position the fan assembly directly on the face of the radiator/condenser. For upstream operation, take care the fan assembly does not foul any struts, bonnet latches etc. For downstream operation take care fan assembly does not foul pulleys, belts etc.
Depending on the space available and the presence of an AC condenser, you may prefer to remove the radiator to ease the fitting procedure.
Separate the radiator fins at the four points where the mounting bolts are to be positioned. Use a ''Phillips head'' screw-driver or very blunt instrument to separate the fins, being careful not to damage the tubes
Secure fan to the radiator using the hardware provided. Ensure the long bolts, fibre and metal washers along with nuts provided are placed in the correct sequence, as per the diagram above.
Please fit the appropriate fuse as per chart below.
If you wish to thematically control the electric fan(s) you should purchase a Davies, Craig Thermatic Switch Kit, Part: #0401, #0400 Combo Kit or a Twin Fan Thermatic Controller Part, #0444 from your retailer. If you wish to cool both the radiator and AC condenser you should purchase Part #0444, or a Thermatic Switch & Relay Kit, Part #0404 - which contains the Thermatic Switch with an extra relay and wiring loom.
0588 FUSE WEDGE 15 AMP x 1
0590 FUSE WEDGE 30 AMP x 1
0513 SCOTCH LOCK 3M 564 x 1
0529 NUT NYLOC 3/16 x 4
0533 RELAY - 12V 40 AMP 5 PIN WITH RESISTOR PROTECTION x 1
0504 BOLT HEX W/F 3x3/16 x 4
0556 WASHER - FIBRE RED x 4
0559 WASHER MUDGUARD SILVER x 4
0512A CONNECTOR (YELLOW) Y3C x 2
0592 HARNESS 12VOLT x 1
0574 RING TERM. (YELLOW) Y3-6 x 1
0613 SCREW - SELF TAP 8X3/8 BZ x 1
10956 Universal Fan Hardware Kit 12V / 24V Instructions x 1
Davies Craig Thermatic Fan Application Guide
|Types||Thermo Fans - Mounting Kits|