K&N 69-7076TS Typhoon Induction Kit fits Nissan 240SX 1994-98
- K&N Typhoon Cold Air Intake system is a free-flowing, mandrel-bent induction kit that replaces your vehicles restrictive air box
- Guaranteed to increase horsepower, improve throttle response and engine sound
- Lasts up to 160,000km between services
- Easy to install, usually in less than 90 minutes
- 9.50 lb (4.32 kg)
- Designed to improve throttle response and engine sound
- Low restriction aluminum tube
- Easy to install, usually in 90 minutes or less
- Lasts up to 160,000km before service is required (depending on driving conditions)
- Replaces stock air intake system
- Washable and reusable lifetime air filter
- K&N Million Mile Limited Warranty
The K&N 69-7076TS Air Intake fits some Nissan 240SX models.
The K&N 69-7076TS Typhoon air intake system is a free-flowing, mandrel-bent aluminum tube air induction system designed to fit some Nissan 240SX models. The restrictive factory air filter and air intake housing are replaced by the K&N Typhoon air intake which is designed to dramatically reduce air flow restriction as it smoothes and straightens air flow. This allows your engine to inhale a larger amount of air than the factory air intake. More air means more usable power and acceleration throughout the engine's RPM range.
The 69-7076TS air intake comes with a black rubber topped K&N high-flow air filter and a heat shield that installs into the previous air box space. Air is directed through the intake tube into the engine's throttle body for a guaranteed power gain. The intake tube has an attractive silver powder-coat finish that's made to last and it accommodates the factory mass air sensor and air temperature sensor as well as a replacement silicone crank case vent hose and EGRC solenoid vent hose. The oversized cone shaped air filter can be used for up to 160,000km before servicing is needed depending on driving conditions. This air intake is relatively easy to install usually in 90 minutes or less using existing factory mounting points. The tools needed are a screwdriver, pliers, ratchet set and some wrenches.
|Specification||Complete Cold Air|
|Types||Cold Air Intakes|
|Warranty||Limited million mile manufacturer's warranty.|